How To Fix A Inglis Refrigerator That’s Not Dispensing Ice

A refrigerator is an essential piece of equipment for any household, keeping our drinks and food cold. It can be annoying and frustrating to have ice not dispersing. There are several reasons that a Inglis refrigerator can stop making ice like a broken dispenser motor, a jammed water filter, or a malfunctioning ice maker. In this article, we’ll go over several common troubleshooting techniques to assist you in fixing your Inglis refrigerator’s ice maker, and make it back up and functioning. It is possible to save money by having a professional service your appliance and not having to purchase a brand new one.

Inglis Ice Bucket Auger Motor

The Inglis Ice Bucket Auger is located in the ice container and when the dispenser is turned on, will rotate to pull the ice towards the outlet chute in the bin. The auger is operated by a motor that is positioned behind the bin and is equipped with the drive forks mounted on the shaft of the gearbox. Although the gear box is slow, it is equipped with lots of power to push the ice. You should verify whether the motor is operating before turning the auger. You should be able to hear the gear box or motor making enough noise to be heard when the freezer door closed.

If the motor isn’t running, then you should test it for continuity with an instrument such as a multi-meter. Unplug the appliance from power prior to performing the test. You should check that the motor is getting power from the desired ice machine if it has continuity. This is an actual voltage test and is only performed by certified personnel. You should inspect the switch and actuators for control if no power is being supplied to the motor terminals.

Inglis Ice Dispenser Actuator

The actuator of the ice maker is the mechanism that is responsible for activating the micro switch in the dispenser. The actuator is typically an incredibly small lever made of plastic that rotates when the tumbler is hit. It could also be covered by the soft pad. The switch usually clicks when it is placed in contact with. If the motor of the auger and the dispenser door are not receiving electricity, you must examine the switch and actuator. Remove the cover from the control panel and make sure that the actuator is in contact with the switch on the dispenser correctly and If not, inspect the bracket housing for the actuator, the bracket that mounts the switch, and the pivot for the actuator. Repair any damaged or damaged parts. It is necessary to replace any defective parts whenever the actuator touches the switch. If you are working near electrical circuits, it is recommended to remove the power source to the device.

Inglis Micro Switch

Momentary contact switch, also known as micro switch in the dispenser, is used to start the motor for the auger. It is situated behind the pad or lever which is used to dispensate ice. To open the switch, you will first need to shut off the power supply. Next, remove the cover from the control panel. It is possible to check the power source with a multi-meter.

Inglis Dispenser Control Board

Certain models of Inglis refrigerators have an electronic control to provide electricity to the auger motor and dispenser door solenoid. It could be that the controller is defective. Inglis electronic controller if they cease to electricity and the actuator or switch isn’t working correctly.

A Inglis refrigerator that doesn’t have the ability to dispense ice can be quite frustrating. However, there are several possible solutions that you can test before making a call to an expert. You can fix the problem yourself by following the suggestions that are described in this post. This can reduce time and cost. Take the time to check the water filter and dispenser motor for any faults. Be patient as you wait for the fresh ice to be made. You can set up the Inglis refrigerator to continue to dispense the ice in the same way, with small amount of effort. This will ensure that your beverages remain cool and refreshing throughout the year.